Power Lines Tester
The Power Lines Tester monitors the following characteristics for critical lines: Voltage between phases and neutral, Working frequency and Ground-Neutral Loop Impedance
Voltage between phases and neutral
With the voltage measurement between phase and neutral, it is possible to detect:
Permanent overvoltages / undervoltages in one or all phases.
Possible voltage decompensations between phases.
Failure of any phase.
Working frequency
With the frequency measurement of the electrical signal, we detect:
A variation in the supplied mains frequency, which can damage or cause equipment to malfunction.
Ground-Neutral Loop Impedance
With the impedance measurement of the loop between neutral and ground we will detect:
Ground fault
Deterioration of the ground connection, which allows us to solve the problem ahead of time.
Related products
SKU: AT-PlugRead More...This SPD is plugged directly in the same socket as the load to be protected. It contains effective protection against transient overvoltages for single-phase power supply lines. Tight protection according to the cascade protection recommended in the Spanish Low Voltage Regulations (REBT ITC23).
SKU: AT-DATARead More...Protection against transient overvoltages for analogical and digital data lines (computers, PLCs, load cells etc.).
SKU: AT-Type23Read More...Type 2 + 3 protectors against transient overvoltages should be tested with 8/20 µs current impulse wave and a combination impulse wave, leaving low residual voltages.
SKU: AT-SurgeRead More...Monitor surge events through an impulse counter for discharges on surge protection devices.